The ARP bench top eyelet machine is an accurate, economical eyelet or grommet setter. Your setting machine came equipped with setting tools which are specific to the eyelet or grommet that you are using. If you need to change eyelet sizes you must also change your setting dies. Always make sure that your setting dies are locked into position with the allen wrench that is supplied. Below is a picture of how the dies look mounted in the machine.
ARP Bench Top Eyelet & Grommet Machine Instructions
SETTING PRESSURE SHOULD ALWAYS BE ADJUSTED WHEN DIES ARE CHANGED OR WORK IS CHANGED. TEST SETTING PRESSURE WITH EYELET ONLY BEFORE TRYING IT IN YOUR WORK
How to Adjust the Setting Pressure on a ARP Bench Top Eyelet Machine
1. Lower top driving shaft down to desired crushing pressure on the eyelet.
2. Adjust top screw until it is touching top driving shaft pin and tighten the lock nut down to secure.
3. To adjust the handle position lever for personal preference, loosen screw on the collar that is on the left side of the machine. Pull shaft out from the right side. Position bar to one's own preference, place back into the machine and reattach collar by locking screw.